After bed leveling (which was a lot easier that I initially thought), Bryson and I were finally ready to make a test run. We decided to run one of the pre-loaded projects that came on the SD card included with the Comgrow Creality Ender 3 Pro

And we were pleasantly impressed with the results:

We had watched a video that indicated printing this little dog would take 5 hours. However, our’s only took about 2. We the realized that the video we watched was of a run on a previous model.

Next we’ll try a custom design run. We’ll start off using Ultimaker Cura since that’s the default software used with the printer. We may move on to something else later on, but for now – so far so good!